![]() For a simpler introduction to Mesecons, see the main site linked above. The primary subject is the design and construction of larger or more advanced machines, a topic not very well covered elsewhere. The actual time the lights are red may be different, due to the yellow and red/yellow states.Here you'll find various articles on the Mesecons mod for Minetest. The actual time the lights are green may be different, due to the yellow and red/yellow states.Īll Red (0-99 seconds, default 5): The length of time from when one set of lights is sent a red signal until the other set is sent a green signal. Side Green (0-99 seconds, default 10): The length of time from when the side lights are sent a green signal until the red signal is sent. Min Cycle (0-99 seconds, default 15): After a cycle, how long until one can be triggered again. Pressing this while a timer is running may result in strange behavior from the lights, and is not recommended, but will not cause any damage. At any time, the down button will enter the menu. ![]() Pressing this button at any other time may result in a malfunction. ![]() When the controller is waiting for a car, the up button will initiate a cycle (simulate a car). The fourth and fifth lines show what controls are available at the time. If a timer is running, the third line will show how long it is waiting for. The second line shows the status of the main street lights ("M:") and the side street lights ("S:"), both either red ("R") or green ("G"). The first line will show whether it is waiting for a timer to finish ("Timing.") or waiting for a car ("Waiting."). In this mode, the LCD shows several pieces of information. Once the setup is complete, it will enter run mode. When done, select "Exit Menu" and press enter. Use the up and down buttons to set the new value, then enter to save it. If you wish to change a parameter, press enter, and brackets will appear around the number to indicate that it is being edited. Use the up and down buttons to scroll through the available parameters. On initial startup, it will enter the menu mode, and the lights will flash. Pin assignments: A - Sensor, B - Enter, C - Down, D - Upĭigiline Channels: "main" - Main street traffic lights, "side" - Side street traffic lights, "lcd" - LCD This is the same program mentioned in the previous post, with a few minor bug fixes, as well as support for retriggering added (the light will cycle as long as there's a car near the sensor). The first version of our new traffic light control program TrafficNeXt was released today. ![]() Manual Published on DecemJanuWebsite Redesign This release also maintains many of the same great features of TrafficNeXt 1.1d, including:Īs always, this is free software, allowed to be redistributed under the terms at the top of the program and bottom of the manual. Simplified internal structure and enhanced software expandibilityĪdditional features have also been added in further updates (the links below are always the latest version):.Support for control panels in any orientation.Improved flexibility of all red interval timing.This is a complete rewrite, bringing many new features: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |